Some jobs require the ability to place holes in custom locations or to cut notches with unusual radii. Some jobs require extra punching power. And, some people prefer the flexibility of a hand punch. The PXXK hand punch from Roper Whitney meets all of these needs. It has one ton of punching power, and the standard kit includes seven punch and dies in a convenient storage case.

The PXXK punch is shown with Roper Whitney's optional bench clamp, and an optional alignment table made by accucutter®. The bench clamp provides a stationary support and, when used with the alignment table, enables the operator to develop set ups for repetitive tasks. The hand punch is easily removed from the bench clamp without affecting the set-up. The picture above shows a typical set-up for the punch, alignment table and bench clamp. However, they are sold separately and are not set-up as shown.

accucutter® has a new die set for PXXK. The sizes listed below are different from the standard die set and are the dies used most frequently.